C$749.95 C$649.00
Availability: In stock (1)

Bennett Standard Hydraulic Trim Tab Kit - Get on plane fast, and stay on plane at intermediate speeds


  • Hydraulic Trim Tab System for boats between 15 and 19 feet
  • Maximize performance while smoothing out the ride
  • Lifting the stern in proportion to speed, weight distribution, and fuel load changes:
    • Enables you to plane at a much lower speed which improves running inefficiently and saves money
    • Increases operator's sight lines which make for a safer ride, especially in congested waters or foul weather
  • Reduce fuel consumption, laboring of engines, hull stress, and pounding
  • Eliminate squatting, listing and porpoising
  • Increase speed while improving visibility and handling
  • Includes Euro-Style Rocker Switch Control (ES2000)
    • Basic rocker switch control allows you to independently raise or lower the port and starboard trim tabs
    • Positive click action for precise trim tab adjustment
    • Water resistant
    • Ergonomic design
    • Easy to install
    • Economical
    • Includes 20' wire harness
    • Operational examples:
      • To lower the starboard bow, press the right (starboard) top portion of the rocker switch
        • This lowers the port tab
      • To lower the port bow, press the left (port) top portion of the rocker switch
        • This lowers the starboard tab
  • Includes Hydraulic Power Unit (Mounting bracket sold separately # H1179)
    • Creates hydraulic pressure to lower and raise the trim tabs
    • Uses two solenoid valves to direct the flow of fluid to the actuators that lock tightly to secure the tabs in place
    • Lexan cover provides water resistance to the electrohydraulic unit, and the translucent reservoir allows fluid check at a glance
    • Hydraulic Power Unit measures 4" x 7 1/2" x 5 1/2"
    • Uses automatic transmission fluid
    • Includes pump, solenoid valves, reservoir and cover

Kit includes:

  • (2) stainless steel trim tab planes
  • (2) nylon / composite actuators
  • Euro-Style Rocker Switch Control (ES2000)
  • Hydraulic power unit includes:
    • pump
    • solenoid valves
    • reservoir
    • cover
    • (Mounting bracket sold separately # H1179)
  • All necessary wiring, tubing and mounting hardware
  • Installation instructions


  • Recommended Boat Length: 15' - 19'
  • Engine Configuration: single I/O, single outboard or inboard
  • Trim Tab Dimensions: 12" span x 9" chord
  • Actuator: single hydraulic
  • Material: stainless steel (trim tabs), high impact nylon / composite (actuators)
  • Nominal Voltage: 12 Volt DC
  • Fuse: 20 Amp
0 stars based on 0 reviews